DD+DIS150.06E
Software Menus, Settings
Document Node ID: 12153275
eq_03-7_menus-setting_e_template_v01
DOCUMENT CONTROL NOTE:
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
Edition 1, Revision 0 CR30-X Chapter 3.7 / I
Type 5175/100 Agfa Company Confidential
Chapter 3.7
Chapter 3.7, Software Menus, Settings is intentionally left blank.
The digitizer CR30-X does not have device specific settings which may be
altered by the service engineer.
All settings are either determined in production and stored in E-Lables in the
corresponding module, or - at replacement of parts - have to be determined
again by an adjustment routine. These new values are automatically written to
the corresponding E-Label.
To Next Page
Loading...
