Chapter 6 267
Replacement Procedure
Front Panel Removal
6. Replacement Procedure
Front Panel Removal
Tools required
• TORX screwdriver, T10, T15, and T20
• Flat edge screwdriver
Procedure
Refer to Figure 6-2 for this procedure.
Step 1. Remove the outer cover as described in “Outer Cover Removal” on page 266.
Step 2. Remove the top trim (item 1) using a flat edge driver.
Step 3. Remove the seven TORX T15 screws (item 2 ) fastening front panel.
Step 4. Release the cable (item 3) from the cable clamp (item 4).
Step 5. Release the two cable (item 6) from the cable clamp (item 5).
Step 6. Gradually push the front panel assembly towards the outside.
Figure 6-2 Front Panel Removal
e5071cse1095
Top
Bottom
Bottom
Top
3
1
4
2
2 5 6
To Next Page
Loading...
