270 Chapter 6
Replacement Procedure
Removable Hard Disk Drive Replacement
Removable Hard Disk Drive Replacement
Tools Required
• TORX screwdriver, T10
• Torque screwdriver, TORX T10 (set to 0.29 N-m / 2.6 lb-in)
Removal procedure
Refer to Figure 6-4 for this procedure.
Step 1. Insert the key (P/N 0960-2562) in the lock and turn clockwise (item 1).
Step 2. Press the button under the lock (item 2) and remove the hard disk (item 3).
Step 3. Remove the four TORX T10 screws (item 4), and remove the removable hard disk drive’s
lid (item 5).
Step 4. Remove the four TORX T10 screws (item 6) fastening the HDD bracket and remove it.
Step 5. Remove the hard disk drive (item 7) from the connector board.
To Next Page
Loading...
Need help?
General
