Agilent Technologies InfiniiVision 3000 X-Series - Page 219

Measurements 14
Agilent InfiniiVision 3000 X-Series Oscilloscopes User's Guide 219
Power App
Measurements
Note that additional Power App measurements are available when the
DSOX3PWR power measurement and analysis license is installed and the
Power Application is enabled. For more information, see the DSOX3PWR
Power Measurement Application User's Guide at
"www.agilent.com/find/3000X- Series- manual" or on the Documentation CD.
Dual-Channel
(N2820A Probe)
Measurements
Note that additional measurements are available with the N2820A
high- sensitivity current probe when both the Primary and Secondary
probe cables are used. Zoom In waveform data below the probe's clamp
level is joined with Zoom Out waveform data above the probe's clamp level
to create the waveform on which the measurement is made. These
measurements are only valid for analog input channels.
"Phase" on page 233 Measures between two sources.
Press Settings to specify the
second source.
"Preshoot" on page 225
"Ratio" on page 228 Measures between two sources.
Press Settings to specify the
second source.
"Rise Time" on page 232
"DC RMS" on page 226
"AC RMS" on page 226
"Top" on page 222
"+ Width" on page 231 Yes
"– Width" on page 231 Yes
"X at Max Y" on page 235 Yes The resultant units are in Hertz.
"X at Min Y" on page 234 Yes The resultant units are in Hertz.
*
Use the cursors to make other measurements on FFT.
Measurement Valid
for
Math
FFT
*
Valid for
Digital
Channels
Notes