Configuring a VPRN Service with CLI
Page 884 7750 SR OS Services Guide
local-proxy-arp
Enables local proxy ARP on the interface. 981
mac
Assigns a specific MAC address to a VPRN interface. 982
proxy-arp-policy
Configures a proxy ARP policy for the interface. 982
remote-proxy-arp
Enables remote proxy ARP on the interface. 983
tos-marking-state
Changes the default trusted state to a non-trusted state. 985
Configure IES group interface SRRP parameters
config>service>ies>sub-if>grp-if>srrp
gw-mac Overrides the default SRRP gateway MAC address used by the SRRP
instance.
1035
keep-alive-interval
defines the interval between SRRP advertisement messages sent when
operating in the master state.
1036
message-path
defines a specific SAP for SRRP in-band messaging. 1036
policy
associates one or more VRRP policies with the SRRP instance. 1038
priority
overrides the default base priority for the SRRP instance. 1038
no shutdown
Administratively enables the entity. 951
Configure VPRN service PIM parameters 906
config>service>vprn>pim
apply-to
Creates a PIM interface with default parameters. 1048
import
Specifies the import route policy to be used for determining which
routes are accepted from peers.
1048
mdt
Enables the context for a multicast distribution tree (MDT) to carry
multicast traffic from customer sites associated with the multicast
domain.
1053
data
Configures a pool of addresses that can be used to generate data only
MDT tunnels.
1054
data-delay-interval
Configures the data delay interval in seconds. 1054
data-threshold
Configures threshold for a group prefix. 1054
default
Configures a default multicast distribution tree (MDT) group address
used by the core instance of PIM to identify multicast traffic for this
VPRN instance.
1055
join-tlv-packing-
disable
Enables the packing of multiple MDT join TLVs. 1055
non-dr-attract-traffic
Specifies whether the router should ignore the designated router state
and attract traffic even when it is not the designater router.
1055
hello-interval
Configures the frequency at which PIM Hello messages are transmitted
on this interface.
1050
Table 1: CLI Commands to Configure VPRN Service Parameters (Continued)
Command Description Page
To Next Page
Loading...
