Alcatel-Lucent 7750 SR OS - Page 885

Virtual Private Routed Network Services
7750 SR OS Services Guide Page 885
hello-multiplier
Configures the multiplier to determine the holdtime for a PIM
neighbor.
1050
improved-assert
Enables improved assert processing on this interface. 1051
max-groups
Configures the maximum number of groups for which PIM can have
downstream state based on received PIM Joins on this interface.
1051
tracking-support
Sets the the T bit in the LAN Prune Delay option of the Hello Message. 1053
ssm-groups
Enables access to the context to enable a source-specific multicast
(SSM) configuration instance.
1062
group-range
Configures the group address or range of group addresses for which
this router can be the rendezvous point (RP).
1059
no shutdown
Administratively enables the VPRN PIM instance. 951
Configure VPRN service PIM interface parameters 916
config>service>vprn>pim>interface
bsm-check-rtr-alert
Enables the checking of router alert option in the bootstrap messages
received on this interface.
1050
hello-interval
Configures the frequency at which PIM Hello messages are transmitted
on this interface.
1050
multicast-senders
Configures the way subnet matching is done for incoming data packets
on this interface.
1051
priority
Sets the priority value to become the rendezvous point (RP) that is
included in bootstrap messages sent by the router.
1052
tracking-support
Sets the the T bit in the LAN Prune Delay option of the Hello Message. 1053
no shutdown
Administratively enables the VPRN PIM interface. 951
config>service>vprn>pim>rp
anycast
Configures a PIM anycast protocol instance for the RP being
configured.
1056
rp-set-peer
Configures a peer in the anycast rp-set. The address identifies the
address used by the other node as the RP candidacy address for the
same multicast group address range as configured on this node.
1057
bootstrap-export
Exports policies to control the flow of bootstrap messages from the RP.
Up to five policies can be defined.
1057
bootstrap-import
Imports policies to control the flow of bootstrap messages into the RP. 1057
bsr-candidate
Enables the context to configure a local rendezvous point (RP) of a
PIM protocol instance.
1058
rp-candidate
Enables the context to configure the candidate rendezvous point (RP)
parameters.
1059
Table 1: CLI Commands to Configure VPRN Service Parameters (Continued)
Command Description Page