Configuring a VPRN Service with CLI
Page 886 7750 SR OS Services Guide
static
Enables access to the context to configure a static rendezvous point
(RP) of a PIM-SM protocol instance.
1060
address
Configures the static rendezvous point (RP) address. 1060
hash-mask-len
Configure the length of a mask that is to be combined with the group
address before the hash function is called.
1058
priority
Configures the priority used to become the rendezvous point (RP). 1058
group-range
Configures the group address or range of group addresses for which
this router can be the rendezvous point (RP).
1059
holdtime
Configures the length of time neighboring routers consider this router
to be up.
1059
group-prefix
Configures the multicast group-address prefix which contains
multicast group-addresses that are imbedded in the join or prune packet
as a filter criterion.
1061
no shutdown
Administratively enables the RP BSR or rendezvous point (RP)
candidate.
951
Configure VPRN interface parameters
915
config>service>vprn>interface
address
Assigns the primary IP address, IP subnet, and broadcast address
format to an IP interface.
978
allow-directed-
broadcast
Enables directed broadcast forwarding out of the IP interface. 980
arp-populate
Enables populating static and dynamic hosts into the system ARP
cache.
1009
arp-timeout
Configures the minimum time, in seconds, an ARP entry learned on the
IP interface is stored in the ARP table.
1010
authentication-policy
Configures the authentication policy for this policy. 1011
bfd
Specifies the bi-directional forwarding parameters for the IP interface. 980
cflowd
Configures cflowd collection and analysis on the (routeable) interface. 981
description
Creates a text description for the interface. 952
dhcp
Enables the context to configure DHCP parameters. 987
host
Configures one or more hosts on this SAP. 1013
local-proxy-arp
Enables local proxy ARP on an interface. 981
loopback
Configures the interface as a loopback interface. This command cannot
be issued if a SAP is defined on the interface.
981
mac
Assigns a specific MAC address to an IP interface. 982
proxy-arp
Configures a proxy ARP policy for the interface. 982
Table 1: CLI Commands to Configure VPRN Service Parameters (Continued)
Command Description Page
To Next Page
