50 Rockwell Automation Publication 1769-UM022C-EN-P - June 2018
Chapter 3 Complete the Controller Setup
Complete these steps to use the AutoFlash utility to load firmware.
1. Make sure that the network connection is made and your network driver
is configured in RSLinx Classic software.
2. Create a controller project.
3. Click RSWho to specify the controller path.
The RSWho Active dialog box appears
4. Navigate over the Ethernet network and select the Compact
GuardLogix controller.
5. Click Download.
IMPORTANT These steps show a 1769-L36ERMS controller. The same steps would also
apply to all Compact GuardLogix 5370 controllers with slight variations in
screens.
TIP You can click Update Firmware instead of Download to complete this
process. If you do so, skip to step 6
.
To Next Page
Loading...
