Argo S - Page 18

General Information Argo Service Manual
Ontario Drive & Gear Limited www.odg.com
PH.(519)- 662-2840 FAX (519)- 662-2421
GI-14
Vehicle Body and Firewall
Hood Hinge Mounting Bolts...........................................Snug By Hand
Rear Seat Mounting Bolts...............................................Snug By Hand
Trailer Hitch Mounting Bolts..........................................35 FT. LBS. 47.5Nm
Trailer Hitch Ball............................................................ 100 FT. LBS. 135.6Nm
Frame and Drive System
Wheel Nuts......................................................................45 FT. LBS. 61.0Nm
Bearing Extensions ........................................................ 30 FT. LBS. 40.7Nm
Bearing Extension Bolts................................................. 240 IN. LBS. 27.1Nm
Bearing Extension Flange Nuts (Avenger).....................30 FT. LBS 40.7Nm
Axle Flange Bolts........................................................... 30 FT. LBS. 40.7Nm
Battery Bracket to Frame................................................30 FT. LBS. 40.7Nm
Axle Sprocket Retaining Screws................................... 144 IN. LBS 16.4Nm
Axle Bearing Set Screws................................................ 10-15 IN. LBS 1.1-1.6Nm
Axle Retaining Bolt........................................................ 35 FT. LBS 47.5Nm
Wheel Stud Extensions................................................... 45 FT. LBS 61.0Nm
Fuel System and Seat Assembly
Handrail Assembly to UpperbodyHand Tight Approx... 48 IN. LBS 5.4Nm
Backpad to Handrail Assembly.......................................72 IN.LBS 8.1Nm
Angle Bracket to Seat Assembly.....................................72 IN.LBS 8.1Nm
Seat Frame Assembly to Frame..................... ................72 IN.LBS 8.1Nm
Seat Frame Assembly to Body........................................ Snug By Hand
Electrical System
Battery Retaining Bracket...............................................Snug By Hand
Brake Sprocket to Disc (Avenger)...................................15 FT. LBS 20.3Nm
Master Cylinder Lid Screws........................................... Snug By Hand
Upper Handle Bar Clamp Bolts (Avenger).....................12 Ft. LBS 16.3Nm
Steering Shaft Nut................ .......................................Tighten snug. Back off until
lower washer can be turned by
hand. Ensure shaft can be turned
with minimal end play
Argo Torque Specifications
Brake Disc to Output Shaft.............................................30FT.LBS 40.7 Nm