Ontario Drive & Gear Limited www.odg.com
PH.(519)- 662-2840 FAX (519)- 662-2421
Transmission Argo Service Manual
TR-36
Assembling the Housing and Cover
25. Install a Retaining Ring into the inner groove on the Output Shaft side of the Trans-
mission Cover. Photo TR-116 & 117
26. Install the Bearing into the Side Cover with the arbor press. Seat it to the previously
installed Retaining Ring. Photo TR-118 & 119
27. Apply yellow LOCTITE 641 to the
outer edge of (2) Bearings and press
them into the Side Cover. Be sure the
shielded side is facing down. Photo TR-
120, 121 & 122
TR-116
TR-117
TR-118
TR-119
TR-120
IMPORIMPOR
IMPORIMPOR
IMPOR
TT
TT
T
ANTANT
ANTANT
ANT
Vehicles Manufactured prior to S/N
CB17471, RB17525, BF11917, SN11905 &
S11906 require 2 retainings rings to be
installed to the cover first before the
bearings are pressed into place.
To Next Page
Loading...
