EasyManua.ls Logo

Argo S - Installing the Drain Plugs; Removing the Drain Plugs

Argo S
438 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Vehicle Body Argo Service Manual
Ontario Drive & Gear Limited www.odg.com
PH.(519)- 662-2840 FAX (519)- 662-2421
VB-10
VB-15 VB-16
Removing the Drain Plugs
There are 2 drain plugs installed into the lower body. These drain plugs provide a means
of removing any water that may have found its way into the lower part of the vehicle drive
train. To access the plugs you will need to perform the servicing procedure, Removing
the Rear Floor Pan. See Photo VB-14
Exact location of drain plug depends on year
and model of Argo
VB-14
1. Locate the plug and lift the lever up-
wards to loosen the plug.
2. Pull the plug from the lower body hole.
Installing the Drain Plugs
1. Seat the rubber portion of the drain plug
properly in the lower body hole and push the lever down to lock plug in place.
Photo VB-15 To tighten the drain plug, lift the lever up and turn the lever clockwise
until it is snug when the lever is pushed back down. Photo VB-16
Relace worn or inoperative drain plugs immediately.
the handrail up and out of the seat frame below. Backrest handrails of this design are no
longer available. If a replacement is required, the vehicle will need to be updated to the
newer style backrest assembly.

Table of Contents

Related product manuals