Argo Service Manual Clutch System
Ontario Drive & Gear Limited www.odg.com
PH.(519)- 662-2840 FAX (519)- 662-2421
CS-11
7. On all RB, BF, SN, S, R, N & B Models,(Briggs & Stratton), remove the lower
retaining ring from the fixed pulley shaft. Photo CS-18
All CB, C & A Models (Conquest) driver clutches have a machined shoulder on the shaft
of the fixed half pulley. This eliminates the need for a retaining ring at this location.
8. Separate the two halves. Photo CS-19
9. Wash clutch components in a clean varsol bath to eliminate accumulated dirt and
grease build up.
10. Perform the servicing procedure, Driver Clutch Inspection, in this section of the
service guide.
Assembling the Driver Clutch (Threaded Bushing Spring Cap)
îš‹îš‹
îš‹îš‹
îš‹ On vehicles manufactured prior to serial numbers CB14236, RB14121, BF9347,
SN9551 & S9596:
1. Place the fixed face on a clean work
surface with the shaft facing up.
Photo CS-20
2. Slip the moveable face on to the shaft
of the fixed face pulley. Photo CS-21
CS-18 CS-19
CS-20
To Next Page
Loading...
Need help?
General
