Argo Service Manual Wheels, Axles & Chains
Ontario Drive & Gear Limited www.odg.com
PH.(519)- 662-2840 FAX (519)- 662-2421
1. Perform the servicing procedure, Installing the Axle Seals, in the Wheels, Axles &
Chains section of the 673-04 Argo Service Guide.
Installing the Front Axle (Avenger Models)
2. Slip the greasable flange over the axle and slide it up close to the hub. Install the
bearing to the shaft with the collar side facing up. Position it such that the set screw
holes in the collar will be aligned and centred with the flat machined surface on the
axle closest to the hub.
Loosen off or remove the set screws from the new bearing before slipping it on to the
axle.
WA-8
WA-9
3. Apply Blue LOCTITE to the set screws and secure to the axle shaft. Torque to
specifications. Photo WA-8
4. Fill the inner grease cavity with axle grease (Lithium based, NLGI #2 or 3 mineral
oil based), using a hand grease gun. Photo WA-9
5. Set the greasable flange to the bearing aligning the grease fitting with the small hole
in the bearing. Photo WA-10 & 11
WA-10 WA-11
WA-52A
To Next Page
Loading...
