Argo Service Manual Vehicle Body
Ontario Drive & Gear Limited www.odg.com
PH.(519)- 662-2840 FAX (519)- 662-2421
VB-13
• Using a 3/16" drill bit, drill upward through the upper body, using the existing holes
in the lower body as guides.
• place body rivets through each hole. Hold a washer over the end of each rivet and
fasten using a rivet gun. Refer to your illustrated parts manual for correct hardware
description.
• using a jigsaw, trim the upper body to match the lower body.
10. If the upper body is NOT a new replacement:
• align the existing holes in the upper and lower bodies and secure with several sets of
clamps around the entire perimeter of the vehicle.
• place rivets through each hole. Hold a washer over the end of each rivet and fasten
with a rivet gun. Refer to your illustrated parts manual for correct hardware descrip-
tion.
11. Remove the plug from the filler neck and install the gas cap.
12. Reinstall the choke cable
13. Connect all wiring to ignition switch, solenoid, engine harness and battery.
14. Install the exhaust system and air intake assemblies as outlined in the Ducting and
Exhaust section of this service guide.
16. Install floorpans and firewall as outlined in this section of the service guide.
17. Reconnect any accessories to the upper body.
18. Install the engine access cover.
15. Install the vinyl bumper
Lower body Removal
1. Perform the servicing procedure, Upper Body Removal, on the previous pages.
2. Perform the servicing procedure, Removing the Fuel Tank, as outlined in section FS
of this service guide
3. Remove all drive chains according to the servicing procedure, Drive Chain Re-
moval, in section WA of this service guide.
4. Perform the servicing procedure, Idler Chain Removal, in section WA of this serv-
ice guide.
5. Remove the power pack assembly as outlined in the Engine System section of this
service guide.
To Next Page
Loading...
