BR-15A
Assembling the Left Hand Side Emergency/Parking Brake
Caliper
12. Install the live side housing to the inside of the brake
disc. Insert (2) two mounting bolts with spacers to the
head of each bolt. Place a thin washer (to each bolt) on
the inside of the mounting bracket. Figure 9.
Figure 9 - Remounting Dead and Live Side Housings
13. Install the shim plate over the (2) two mounting bolts.
Figure 10.
14. Next, install two thick washers to the mounting bolts
along with the dead side housing which is placed to the
outside of the brake disc. Figure 11.
Figure 10 - Shim.
Figure 11- Dead Side Housing.
15. Install (2) more spacers to the ends of the mounting bolts.
Figure 12.
16. Secure with the nylon locknuts and torque caliper assem-
bly to 215in. lbs. (24Nm) Figure 13.
.
Figure 12 - Spacers.
Figure B - Right Side.
Ontario Drive & Gear
Phone (519) 662-2840 Fax (519) 662-2421
To Next Page
Loading...
