General Information Argo Service Manual
Ontario Drive & Gear Limited www.odg.com
PH.(519)- 662-2840 FAX (519)- 662-2421
GI-26
7R VICE GRIP MODIFICATION
A pair of modified 7R Vice Grips is required
to hold the ends of the drive chain together
while inserting the connecting link. This tool
can also be used to hold the ends of the idler
chain together while inserting the connecting
link. Grind the undercut and sides of the vice
grip jaw to fit over 2 chain rollers. The
undercut is approximately 1/4" radius as
shown.
658-20 Tool, Driven Clutch Service
To Next Page
Loading...
