Clutch System Argo Service Manual
Ontario Drive & Gear Limited www.odg.com
PH.(519)- 662-2840 FAX (519)- 662-2421
CS-24
CS-53A
CS-55
CS-56
Make sure that the retaining ring is seated to the groove. Failure to guarantee that it
is seated, could result in personal injury while handling the clutch or damage to the
vehicle once installed.
5. Install the cam and spring to the fixed face shaft aligning the key on the fixed shaft
with the keyway in the cam. Photo CS-55
6. Take to the arbor press and push the cam onto the shaft while turning the movable
face counter clockwise 120 degrees, or one cam notch past the first cam shoe . Once
past the cam shoe, press completely down until the retaining ring groove in the
fixed pulley shaft is visible and the retaining ring can be reinstalled.
Photo CS-56
All Driven Clutches
CS-54A
To Next Page
Loading...
