Wheels, Axles & Chains Argo Service Manual
Ontario Drive & Gear Limited www.odg.com
PH.(519)- 662-2840 FAX (519)- 662-2421
WA-14
2. Locate the required chain take up system and remove the tensioner spring. Photo
WA-18
WA-19WA-18
3. Remove the cotter pin which secures the chain tensioner system to the vehicle
frame. Photo WA-19
4. Slide out the pivot pin which holds the chain tensioner assembly together. Photo
WA-20
WA-20 WA-21
6. If the nylon slider block needs replac-
ing, place the tensioner arm in a vise and
lift one corner of the slider block, pull-
ing it straight back off the chain
tensioner arm. DIAGRAM WA-22
5. Pull the upper and lower assembly from the vehicle and collect the remaining com-
ponents of the assembly. These include a spacer and spacer spring. Photo WA-21
WA-22
To Next Page
Loading...
