Ontario Drive & Gear Limited www.odg.com
PH.(519)- 662-2840 FAX (519)- 662-2421
Transmission Argo Service Manual
TR-2
Detailed information on standard workshop and safety procedures, and general
servicing operations is not included in this manual, which has been prepared to assist
qualified service personnel. ODG assumes no responsibility or liability for
PERSONAL INJURY or VEHICLE DAMAGE which results from any servicing
procedure performed, including those instructions outlined in this manual. Before
performing a servicing operation, an individual must have determined to his/her
satisfaction that a personal injury or vehicle damage will not result from the
servicing procedure or tools selected.
General Instructions
All transmission work should be performed by a qualified mechanic. Severe damage
and/or reduced performance can result from an improperly serviced transmission.
Do not attempt to move the gearshift from the neutral starting position until the
engine idles down completely. The Argo is equipped with an automatic clutch that is
activated by engine speed. If the engine idle speed is too high, the transmission will
grind during gear engagement.
To Next Page
Loading...
Need help?
General
