Ontario Drive & Gear Limited www.odg.com
PH.(519)- 662-2840 FAX (519)- 662-2421
Transmission Argo Service Manual
TR-26
Transmission Component Description of Change
Transmission Cover
Aug 11/2000 The side cover is cast solid in the area
of the input shaft and shifter assembly at the 101-01
bearings. This eliminates the need for the 31-07 plug
plates & 106-01 retaining rings normally used here.
Fully Exchangeable.
SN11905 TB Oct. 4/00
S11906 TB Oct. 4/00
BF11917 OB Oct. 10/00
CB17471 YB Oct. 12/00
RB17525 TB Oct. 24/00
From Serial Numbers:
Reverse Idler (34-16A)
July 3, 2001 Reverse Idler has two 105-03 bushings
instead of a single, 105-05 bushing, along with two
radial holes drilled in for better lubrication. Fully
Exchangeable
From vehicles manufac-
tured from July 3, 2001
Shim Washer between
Housing and Shifter Assy.
Apr 16/2002 To address the issue of the retaining ring
in some cases, popping off of the shift yoke due to
interference on the casting.
Any transmission being serviced and rebuilt between
Serial Numbers: CB17404 - CB19432, RB17525 -
RB19502, BF11917 - BF13347, SN11905 - SN13349,
or S11906 - S13350, would benefit from having this
new 108-74 shim washer installed at the time of a
rebuild. Even though this may not have been an issue,
it will be a good precautionary measure for the future.
To Next Page
Loading...
