Argo S - Page 413

Ontario Drive & Gear Limited www.odg.com
PH.(519)- 662-2840 FAX (519)- 662-2421
TR-15A
Argo Service Manual Transmission
4. Install the second Thrust Washer to the top of the High Gear Pinion. Photo TR-51
TR-50 TR-51
Transmissions manufactured prior to serial #A2856 utilize 4 dog teeth and from
#A2856, 3 dog teeth. Photo TR-50 Orient the the High Gear Pinion with the dog teeth
facing up.
5. Install the 107-10 retaining ring to secure the second thrust washer. Photo TR-52
6. Slip the 34-103 Dog Clutch (4 Tooth, prior to serial #A2856)or 34-127 Dog Clutch (3
tooth,
from serial #A2856),to the Input Shaft. Photo TR-53
IMPORIMPOR
IMPORIMPOR
IMPOR
TT
TT
T
ANTANT
ANTANT
ANT
The Dog Clutch needs to be oriented correctly when assembled to the Input Shaft.
The dogs on one side of the clutch have a small machined shoulder. These dogs
will engage with the Low Gear Pinion so they face away from the previously
installed High Gear Pinion Photo TR-53
TR-52 TR-53
7. Install the 34-106 Low Gear Pinion (4 Tooth, prior to serial #A2856) or 34-129 (3
tooth,
from serial #A2856)with the dogs facing towards the previously installed Dog
Clutch. Photo TR-54
8. Press the 34-107 Reverse Gear Pinion on to the Input Shaft and up against the Low