Engine System Argo Service Manual
Ontario Drive & Gear Limited www.odg.com
PH. (519)- 662-2840 FAX (519)- 662-2421
5. Disconnect the ground wire attached at the front of the engine to the valve cover
fastener. Photo 7
6. Locate the main wire harness plug-ins at the front of the engine compartment and
disconnect all wires. Photo 8
7 8
7. Locate the starter at the front of the engine compartment and disconnect both red
and black power wires from the starter solenoid. Photo 9 These wires are enclosed
within a red rubber boot.
9
10
8. Remove the drive belt between engine and transmission. Photo 10
9. Remove the driven clutch from the transmission input shaft. Photo 11 & 12
12
11
EN-21A
To Next Page
Loading...
