CHAPTER 4 REFERENCE GUIDE
Page 4-20
091-00019-001 REV B
EFD1000 C3 Pro PFD Pilot’s Guide
Once the Selected Minimums eld value is set to a Decision Altitude, Decision Height,
or Minimum Descent Altitude, the PFD provides an alert when the aircraft descends
below this altitude. To activate this feature, enable the Selected Minimums (MIN) eld
and set the value with the Right Knob.
Display/Hide Minimums
1. Press the MIN Hot Key to alternately hide or display the Selected Minimums
Field, MINIMUMS Annunciation, and Markers (Figures 4-28 and 4-29).
The range for the MIN data eld is 0 – 15,000 feet, in increments of 10 feet. SYNCing sets
the Selected Minimums eld value to the current altitude (Section 2.2.1.3). The default
value is 100 feet, or the previously set value.
NOTE
Pressing the MIN Hot Key presents the MINIMUMS Markers on the Altitude Tape and the
Selected Minimums Field on the Attitude Display. The MIN label above the Right Knob and
the MIN eld value are rendered in magenta for editing.
Figure 4-29
Selected MINIMUMS
Annunciation and Markers
Enabled
Figure 4-28
MIN Hot Key – Selected MINIMUMS
Annunciation and Markers Disabled
To Next Page
Loading...
