Aspen Avionics Evolution EFD 1000 C3 Pro PFD - APPR Mode Operation - ILS Approach with Vectors to Final

CHAPTER 4 REFERENCE GUIDE
Page 4-61
091-00019-001 REV B
EFD1000 C3 Pro PFD Pilot’s Guide
APPR Mode Operation – ILS Approach with Vectors to Final
1. Using the CDI Source Select Button, couple a tuned/valid ILS radio frequency
to the PFD CDI, and adjust the course (CRS) (Section 4.4.7).
2. Set the PFD Heading Bug to a value that will intercept the desired course, or
as instructed by ATC (Section 4.4.9).
3. Engage the autopilot in Heading (HDG) and Altitude (ALT) Hold modes and
verify that the aircraft turns to the desired heading.
4. Once cleared for the ILS approach, arm the autopilot’s Approach (APPR)
mode, or continue to y Heading (HDG) mode until the CDI centers.
5. Monitor the CDI’s deection and verify (if supported by your autopilot) that,
upon intercepting the localizer, the autopilot switches to Approach (APPR)
capture, and tracks the localizer course. Otherwise, engage the autopilot
Navigation or Approach mode per the procedures in your autopilot’s AFMS.
6. Monitor the autopilot localizer tracking performance. Upon intercepting the
glide slope, verify that the autopilot captures the Glide Slope (GS) and initiates
a descent to track the glide slope.