AudioCodes Mediant 1000B SBA - 11.14 Step 14: Test Lync Calls

Installation & Maintenance Manual 118 Document #: LTRT-40111
Mediant 1000B SBA
11.14 Step 14: Test Lync Calls
The Lync Test Call option allows you to test a PSTN call initiated by the Lync Server 2013.
11.14.1 Test Prerequisites
Before running the Lync Test Call, the following prerequisites must be met :

The gateway call has been successfully tested as described above in Section 11.13
on page 115.

Test users have been created in the Lync Server 2013 and are voice-enabled.

VoIP Outbound Routing configuration has been setup and the correct policies
assigned to the test users (for more information, refer to the Mediant 1000B MSBR
User's Manual).

Built-in-users for HealthMonitoring have been configured using the following
commands:
New-CsHealthMonitoringConfiguration -Identity
<XdsGlobalRelativeIdentity> -FirstTestUserSipUri <String> -
SecondTestUserSipUri <String>
Where:
• Identity the FQDN of the pool where the health monitoring configuration settings
are to be assigned (i.e., SBA FQDN).
• FirstTestUserSipUri is the SIP address of the first test user to be configured for
use by this collection of health monitoring settings. Note that the SIP address
must include the sip: prefix, for example:
-FirstTestUserSipUri sip:kenmyer@litwareinc.com
• SecondTestUserSipUri is the SIP address of the second test user to be
configured for use by this collection of health monitoring settings. Note that the
SIP address must include the sip: prefix, for example:
-SecondTestUserSipUri sip:jhaas@litwareinc.com