Installation & Maintenance Manual 228 Document #: LTRT-40111
Mediant 1000B SBA
• If you are connecting to the network via an external NIC:
♦ OSN3B/OSN4: Using a network cable, connect one of the Ethernet ports (1
or 2) (labeled ) on the OSN3B/OSN4 module to the network:
Figure 30-15: Connecting to LAN Port on OSN3B and OSN4 Module (Rear Panel View)
♦ OSN3: Using a network cable, connect the Ethernet port (labeled ) on
the OSN3 module to the network:
Figure 30-16: Connecting to LAN Port on OSN3 Module (Rear Panel View)
2. If you have an HDMI monitor connected, do the following (otherwise, skip to Step 3):
• For connecting to the network via the internal NIC:
a. If you have a DHCP server in your network, the internal NIC should be
identified by a displayed IP address (the two external Ethernet ports should
be displayed as "Disconnected"). If you do not have a DHCP server in your
network, define a static IP address.
b. Skip to Step 9.
To Next Page
Loading...