AudioCodes Mediant 1000B SBA - Defining Network Parameters; Defining the SBA Image File Name

Installation & Maintenance Manual 29. Preparing SBA Upgrade and Recovery
Version 6.8 213 Microsoft Lync Server
29.7 Defining Network Parameters
You can configure the network parameters for the SBA upgrade and recovery process,
using the parameters under the [NetworkCardConfiguration] section in the *.ini file.
Note: These network settings are used only for communication between the OSN and an
FTP server or a local network for downloading the image file, as described in
Section 29.9 on page 214. The IP address of the OSN LAN port is assigned only after
initialization (by a DHCP server or manually), as described in Section 30.4 on page 15.

Use DHCP for obtaining IP address (recommended and default): Set the EnableDhcp
to 1, as shown below:
[NetworkCardConfiguration] EnableDhcp=1
This is only applicable if you have a DHCP server in your network.

Manually (Static) define IP address: Set the EnableDhcp to 0, as shown below:
[NetworkCardConfiguration] EnableDhcp=0
When set for static IP address, configure the static network address, as shown below:
• IpAddress: Defines the static IP address:
[NetworkCardConfiguration] IpAddress=10.21.22.55
• SubnetMask: Defines the subnet:
[NetworkCardConfiguration] SubnetMask=255.255.0.0
• DefaultGateway: Defines the default gateway:
[NetworkCardConfiguration] DefaultGateway=10.21.0.1
• DnsServers: Defines the domain name server (DNS):
[NetworkCardConfiguration] DnsServers=10.1.1.11
29.8 Defining the SBA Image File Name
You can configure the SBA image file name for the SBA upgrade and recovery, using the
Filename parameter.
[WIM Filename] Filename
Note: By default, the name of the image file is
for example,
SBA_OSN3_1_1_11_40.wim.