Installation & Maintenance Manual 98 Document #: LTRT-40111
Mediant 1000B SBA
Figure 11-29: Device Preparation – Reboot Message Box
4. Click OK, and then do one of the following:
• If all steps have been completed successfully, click Reboot.
• If you wish to review some of the steps, refer to the Detailed Log for corrective
information, rectify the problem, and then click Apply to install the remaining
components.
When you relogin to the SBA, a green check mark appears next to the 'Device
Preparation' option under the Setup tab, as shown in the figure below.
Figure 11-30: Device Preparation – Completed Successfully
To Next Page
Loading...