Installation & Maintenance Manual 30. SBA Upgrade and Recovery
Version 6.8 227 Microsoft Lync Server
Notes:
• This step may take a while (about 10 minutes). While the Mediant 1000B is rebooting,
DO NOT power off the Mediant 1000B.
• During initialization, the OSN server restarts twice.
13. Determine the NIC that is assigned to the required Ethernet port and the
corresponding IP address, and then use this IP address to connect to the SBA (see
Section 30.4).
30.4 Acquiring an IP Address
Once the OSN server has successfully rebooted, you need to identify the NIC
corresponding to the Ethernet port. All Network Interface Cards (NIC) are assigned IP
addresses by your enterprise's DHCP server (if it exists). If you are not using a DHCP
server, you can assign a static IP address to this NIC.
Note: If the SBA was recovered or upgraded using the AudioCodes Upgrade and
Recovery USB dongle, the IP address of the OSN server is received from the DHCP
server and therefore, the pre-configured IP address is no longer applicable.
To acquire an IP address:
1. Do one of the following:
• If you are connecting to the network via the internal NIC:
Connect the first Ethernet port on the CRMX module on the front panel of the
device directly to the network using a straight-through Ethernet cable.
Figure 30-14: Connecting Mediant 1000B SBA LAN Port on CRMX Module (Front Panel)
To Next Page
Loading...