Installation & Maintenance Manual 152 Document #: LTRT-40111
Mediant 1000B SBA
15.1.2 Step 2: Configure the NTP Server
The procedure below describes how to configure the Network Time Protocol (NTP) server.
This is important for maintaining the correct time and date on the PSTN Gateway, by
synchronizing it with a third-party NTP server. This ensures that the PSTN Gateway has
the same date and time as the Certification Authority (CA), discussed later in Section 15.1
on page 151.
To configure the NTP server:
1. Open the Application Settings page (Configuration tab > System menu >
Application Settings).
Figure 15-2: Application Settings Page
2. In the 'NTP Server Address (IP or FQDN)' field, enter the IP address of the NTP
server.
3. Click Submit to apply your changes.
4. On the toolbar, click Burn to save the changes to the PSTN gateway flash memory.
To Next Page
Loading...