AudioCodes Mediant 1000B SBA - Figure 18-2: IP Media Settings

Installation & Maintenance Manual 168 Document #: LTRT-40111
Mediant 1000B SBA
Figure 18-2: IP Media Settings Page
7. From the ‘IPMedia Detectors’ drop-down list, select Enable. This parameter requires a
PSTN Gateway reset (see Step 8 below).
8. From the ‘Enable AGC’ drop-down list, select Enable.
9. Click Submit to apply your changes.
10. On the toolbar, click Burn to save the changes to the PSTN gateway flash memory.
11. On the toolbar, from the Device Actions drop-down list, choose Reset, and then in the‘
Maintenance Actions’ page, click the Reset button; the Mediant 1000B resets and
your settings are saved to the flash memory.