Installation & Maintenance Manual 154 Document #: LTRT-40111
Mediant 1000B SBA
15.1.4 Step 4: Configure the Gateway Name
The procedure below describes how to configure the host name for the PSTN Gateway.
This appears as the URI host name in the SIP From header in INVITE messages sent by
the PSTN Gateway to the Mediation Server. This allows the Mediation Server to identify
the PSTN Gateway (if required), when using certificates for TLS (see Section 15.1.5).
To configure the SIP gateway name:
1. Open the Proxy & Registration page (Configuration tab > VoIP menu > SIP
Definitions > Proxy & Registration).
Figure 15-4: Proxy & Registration Page
2. In the 'Gateway Name' field, assign a unique FQDN name to the PSTN Gateway
within the domain, for example,'gw.lync2013.com'.This name is identical to the name
that is configured in the Lync Topology Builder (see Section 9.1 on page 58).
3. Click Submit to apply your settings.
On the toolbar, click Burn to save the changes to the PSTN gateway flash memory.
To Next Page
Loading...