Installation & Maintenance Manual 282 Document #: LTRT-40111
Mediant 1000B SBA
C.2 Upgrading Enhanced Gateway to SBA
This section describes how to upgrade the hardware of the Mediant 1000B Basic Gateway
R1/R2 and Mediant 1000B Enhanced Gateway to a Mediant 1000B Survivable Branch
Appliance (SBA).
Note: You can upgrade to either the Mediant 1000B SBA-ES SBA or to the Mediant
1000B SBA-EO SBA. For more information, see Chapter 5 on page 27 or contact your
AudioCodes sales representative.
To upgrade to an SBA gateway:
1. Remove the new OSN server modules from their ESD shielding packets in which they
were shipped.
2. Install the HDMX module:
a. Remove the blank-panel slot cover from Slot 1 by gently pulling on the handle of
the module until it slides out of the slot.
b. Hold the HDMX module in the correct orientation, as shown in the figure below,
and gently insert the module into the slot, sliding it along the slot's guide rails until
it makes contact with the card-edge connector (located on the backplane).
Figure C-1: Installing HDMX Module
c. Push the module's handle until it clicks firmly into the slot.
To Next Page
Loading...