AudioCodes Mediant 1000B SBA - Page 182

Installation & Maintenance Manual 182 Document #: LTRT-40111
Mediant 1000B SBA
Parameter Description
NPI Defines the Numbering Plan Indicator (NPI).
 [0] Unknown (default)
 [9] Private
 [1] E.164 Public
 [-1] Not Configured = value received from PSTN/IP is used
Notes:
 This parameter is applicable only to number manipulation tables for
IP-to-Tel calls.
 NPI can be used in the SIP Remote-Party-ID header by using the
EnableRPIHeader and AddTON2RPI parameters.
 .
TON Defines the Type of Number (TON).
 If you selected 'Unknown' for the NPI, you can select Unknown [0].
 If you selected 'Private' for the NPI, you can select Unknown [0],
Level 2 Regional [1], Level 1 Regional [2], PISN Specific [3] or Level
0 Regional (Local) [4].
 If you selected 'E.164 Public' for the NPI, you can select Unknown
[0], International [1], National [2], Network Specific [3], Subscriber [4]
or Abbreviated [6].
The default is 'Unknown'.
Notes:
 This parameter is applicable only to number manipulation tables for
IP-to-Tel calls.
 TON can be used in the SIP Remote-Party-ID header by using the
EnableRPIHeader and AddTON2RPI parameters.
 .
Presentation Enables Caller ID.
 Not Configured = Privacy is determined according to the Caller ID
table.
 [0] Allowed = Sends Caller ID information when a call is made using
these destination/source prefixes.
 [1] Restricted = Restricts Caller ID information for these prefixes.
Notes:
 This field is applicable only to number manipulation tables for source
phone number manipulation.
 If this field is set to Restricted and the 'Asserted Identity Mode'
(AssertedIdMode) parameter is set to P-Asserted, the From header
in the INVITE message includes the following: From: 'anonymous'
<sip: anonymous@anonymous.invalid> and 'privacy: id' header.