AudioCodes Mediant 1000B SBA - Page 52

Installation & Maintenance Manual 52 Document #: LTRT-40111
Mediant 1000B SBA
Parameter Description
Mode (Read-only field) Displays the mode of the port:
 [0] Disable
 [1] Enable (default)
Native Vlan Defines the Native VLAN or PVID of the port. Incoming packets without a
VLAN ID are tagged with this VLAN. For outgoing packets, if the VLAN ID as
defined in the Multiple Interface table is the same as the Native VLAN ID, the
device sends the packet without a VLAN; otherwise, the VLAN ID as defined
in the Multiple Interface table takes precedence.
The valid value range is 1 to 4096. The default is 1.
Speed & Duplex Defines the speed and duplex mode of the port.
 [0] 10BaseT Half Duplex
 [1] 10BaseT Full Duplex
 [2] 100BaseT Half Duplex
 [3] 100BaseT Full Duplex
 [4] Auto Negotiation (default)
 [6] 1000BaseT Half Duplex
 [7] 1000BaseT Full Duplex
Description Defines an arbitrary description of the port.
Group Member (Read-only field) Displays the group to which the port belongs.
Group Status (Read-only) Displays the status of the port:
 "Active" - the active port
 "Redundant" - the standby (redundant) port