AudioCodes Mediant 2600 - Page 437

Version 6.8 437 Mediant 2600 E-SBC
User's Manual 30. Software Upgrade

Web interface - see ''Configuring SBC User Info Table in Web Interface'' on page 437

CLI - see Configuring SBC User Info Table in CLI on page 438

Loadable User Info file - see ''Configuring SBC User Info Table in Loadable Text File''
on page
439
30.1.4.2.1 Configuring SBC User Info Table in Web Interface
The following procedure describes how to configure the SBC User Info table in the Web
interface.
Note: If any User Info file is loaded to the device, all previously configured entries are
removed from the table in the Web interface and replaced with the entries from the
loaded User Info file.
 To configure the SBC User Info table in the Web interface:
1. Open the SBC User Info Table page (Configuration tab > VoIP menu > SIP
Definitions > User Information > SBC User Info Table).
2. Click Add; the following dialog box appears:
Figure 30-1: SBC User Info Table Page
3. Configure the SBC User Info table parameters according to the table below.
4. Click Submit.
5. To save the changes to flash memory, see ''Saving Configuration'' on page 424.
To register a user, select the user's table entry, and then from the Action button's drop-
down list , choose Register. To un-register a user, select the user, and then from the
Action button's drop-down list , choose Un-Register.
Table 30-2: SBC User Info Table Parameter Descriptions
Parameter Description
Index
[SBCUserInfoTable_Index]
Defines an index for the new table record.
Local User
[SBCUserInfoTable_LocalUser]
Defines the user and is used as the Request-URI user part for the
AOR in the database.
The valid value is a string of up to 10 characters.
Username
[SBCUserInfoTable_Username]
Defines the username for registering the user when
authentication is necessary.
The valid value is a string of up to 40 characters.