SIP User's Manual 404 Document #: LTRT-12801
MP-500 MSBG
Parameter Description
Web: Deactivate
EMS: CLIR Deactivation
[KeyCLIRDeact]
Keypad sequence that deactivates the restricted Caller ID
option. After the sequence is pressed, a confirmation tone is
heard.
Keypad Feature - Hotline Parameters
Web: Activate
EMS: Hot Line
[KeyHotLine]
Keypad sequence that activates the delayed hotline option.
To activate the delayed hotline option from the telephone,
perform the following:
 Dial the preconfigured sequence number on the keypad; a
dial tone is heard.
 Dial the telephone number to which the phone automatically
dials after a configurable delay (terminate the number with
#); a confirmation tone is heard.
Web: Deactivate
EMS: Hot Line Deactivation
[KeyHotLineDeact]
Keypad sequence that deactivates the delayed hotline option.
After the sequence is pressed, a confirmation tone is heard.
Keypad Feature - Transfer Parameters
Web: Blind
EMS: Blind Transfer
[KeyBlindTransfer]
Keypad sequence that activates blind transfer for Tel-to-IP
calls. There are two possible scenarios:
 Option 1: After this sequence is dialed, the current call is put
on hold (using Re-INVITE), a dial tone is played to the
phone, and then phone number collection starts.
 Option 2: A Hook-Flash is pressed, the current call is put on
hold, a dial tone is played to the phone, and then digit
collection starts. After this sequence is identified, the device
continues the collection of the destination phone number.
For both options, after the phone number is collected, it's sent
to the transferee in a SIP REFER request (without a Replaces
header). The call is then terminated and a confirmation tone is
played to the phone. If the phone number collection fails due to
a mismatch, a reorder tone is played to the phone.
Notes:
 This parameter is applicable to FXO and FXS interfaces,
but for FXO the Web interface does not display this
parameter.
 It is possible to configure whether the KeyBlindTransfer
code is added as a prefix to the dialed destination number,
by using the parameter KeyBlindTransferAddPrefix (refer to
''Channel Parameters'' on page 425).
Keypad Feature - Call Waiting Parameters
Web: Activate
EMS: Keypad Features CW
[KeyCallWaiting]
Keypad sequence that activates the Call Waiting option. After
the sequence is pressed, a confirmation tone is heard.
Web: Deactivate
EMS: Keypad Features CW Deact
[KeyCallWaitingDeact]
Keypad sequence that deactivates the Call Waiting option.
After the sequence is pressed, a confirmation tone is heard.
To Next Page
Loading...
Need help?
General
