Phone Based Administration Page 111
- Issue 6a (Thursday, February 22, 2018)IP Office Basic Edition
Comments on this document? infodev@avaya.com
Dialing Restrictions and Permissions: Outgoing Call Restriction
ETR 18D/ETR 34D Phone
1. At either or the first two extensions on the system, press Feature 0 0 followed by two presses of the first
intercom or call appearance button.
2. System Administration: is shown on the display.
3. Dial #401. The phone displays Outgoing Call Restr.
4. At the Extension: prompt, enter the number of the extension to be programmed.
5. To change the type of call restriction, enter the required value:
·
1 = No Restriction (can make toll, local and internal calls; this is the default setting).
·
2 = Internal only.
·
3 = Local (internal and local) only.
·
Alternatively use the Next Data or Previous Data buttons to change the setting or press Remove to return
to the default setting.
6. Press the Next Item or Previous Item button for the next or previous extension respectively.
·
Exit programming by pressing Feature 00. You can also exit programming mode by lifting the handset, then
placing it back in the cradle.
To Next Page
Loading...
