Phone Based Administration Page 52
- Issue 6a (Thursday, February 22, 2018)IP Office Basic Edition
Comments on this document? infodev@avaya.com
1.7 Feature Codes
The following feature codes can be dialed from most phones after pressing Feature. Most of these features can also be
assigned to programmable buttons.
This function allows the user to set the extension's do not
disturb on or off.
This function allows the user to send a recall or hook flash
signal.
This function allows the user to save the number dialed
during a call and to redial that number when idle. This can
be used when the number dialed does not answer.
This function allows the user to redial the last external
number dialed.
This function allows the user to drop a call from a
conference.
This function allows the user to turn privacy on or off. When
on, other extensions are not able to bridge into the user's
calls.
This function allows the user to redirect all their calls to
another number. Extensions with Remote Call
Forwarding enabled can also forward calls externally by
specifying a personal speed dial as the destination.
This function allows the user to enter an account code prior
to making a call or during a call.
This function allows the user to transfer their current call to
an extension's mailbox. After pressing the button, the
current call is put on hold and the user can then enter the
target extension number to indicate the mailbox required.
This function allows the user to switch use of voicemail
coverage for their extension on or off.
This function allows the user to swap the display of caller ID
name and number information on their extension.
This function allows the user to see the caller ID of a call on
another line without interrupting the current call to which
they are connected.
This function allows the user to switch call coverage for
their extension on or off. The button settings include the
extension number of the extension providing coverage.
When on, calls to the user that ring unanswered for the
user's number of coverage rings then also start ringing
at the call coverage extensions.
This function allows the user to lock their extension from
being used to make calls. After they press the button, they
are prompted to enter a four digit code after which the
extension is locked. If the extension is already locked,
pressing the button prompts for reentry of the four digit
code to unlock the extension.
This function can only be used by the first two extensions in
the system. This function allows the user to unlock any
extension without needing to know the code that was used
to lock that extension. When the button is pressed, the user
is prompted to enter the number of the locked extension.
258
258
279
281
267
252
277
238
112
141
238
228
291
289
246
242
236
199
285
287
To Next Page
Loading...
