Avaya IP Office Basic Edition - System Default

Phone Based Administration Page 307
- Issue 6a (Thursday, February 22, 2018)IP Office Basic Edition
Comments on this document? infodev@avaya.com
System Maintenance: System Copy
17.7 System Default
Use this feature to reset the system and return its configuration to the default settings. Reset the system only when
advised to do so by technical support personnel.
· ! WARNING
This process will restart the phone system and disconnect all currently connected calls.
· The system reset begins immediately. It takes approximately 5 minutes.
· This procedure is not listed when using the Next Procedure or Previous Procedure buttons to select a
procedure.
1408/1416/9504/9508 Phone
1. At either of the first two extensions on the system, press Admin.
· To do the above during a call, you may need to press the PHONE button to display the Admin soft key
option. If you access phone administration during a call, only the SPEAKER, MUTE and HEADSET
buttons still affect the connected call.
2. Use the up or down arrow buttons to scroll the display to System Administration. When highlighted, press
Select.
3. Dial #989.
4. When the Restart - Defaults: prompt is displayed, dial 25327 (C L E A R).
5. The system will be immediately restarted.
M7324/M7324N/M7310/M7310N/T7316/T7316E Phone
1. At either of the first two extensions on the system, press Feature **config (ie. Feature **266344).
· If the system has a system password set, it is requested. Enter the password.
2. The phone displays System Admin.
3. Dial #989.
4. When the Restart - Default: prompt is displayed, dial 25327 (C L E A R).
5. The system will be immediately restarted.
· To exit phone based administration at any time, press the Release button. To select a different process use the
Next Procedure or Previous Procedure buttons or dial another feature code.
ETR 18D/ETR 34D Phone
1. At either or the first two extensions on the system, press Feature 0 0 followed by two presses of the first
intercom or call appearance button.
2. System Administration: is shown on the display.
3. Dial #989.
4. When the Restart - Defaults: prompt is displayed, dial 25327 (C L E A R).
5. The system will be immediately restarted.
114