Avaya IP Office Basic Edition - Holding Calls; Hold Recall Time

Phone Based Administration Page 218
- Issue 6a (Thursday, February 22, 2018)IP Office Basic Edition
Comments on this document? infodev@avaya.com
15. Holding Calls
15.1 Hold Recall Time
Set how long a call can be placed on hold before recalling to the extension that put it on hold if that extension is idle.
1408/1416/9504/9508 Phone
1. At either of the first two extensions on the system, press Admin.
· To do the above during a call, you may need to press the PHONE button to display the Admin soft key
option. If you access phone administration during a call, only the SPEAKER, MUTE and HEADSET
buttons still affect the connected call.
2. Use the up or down arrow buttons to scroll the display to System Administration. When highlighted, press
Select.
3. Use the up or down arrow buttons to scroll the display to System Parameters. When highlighted, press
Select.
· Alternatively, dial # and the system administration code.
4. Use the up or down arrow buttons to scroll the display to Hold Timer. When highlighted, press Select.
5. The current setting is displayed.
6. Enter then option required 0 (off) to 9. The default is 5 (60 seconds).
0 = Not Active
2 = 20 seconds
4 = 45 seconds
6 = 90 seconds
8 = 150 seconds
1 = 10 seconds
3 = 30 seconds
5 = 60 seconds
7 = 120 seconds
9 = 180 seconds
· Alternatively use the left or right arrow icons to toggle through the settings or Default to return to the
default setting.
· Exit programming by pressing PHONE. Alternatively use the Back button to move to another menu.
M7324/M7324N/M7310/M7310N/T7316/T7316E Phone
1. At either of the first two extensions on the system, press Feature **config (ie. Feature **266344).
· If the system has a system password set, it is requested. Enter the password.
2. The phone displays System Admin.
3. Dial #127. The phone displays Hold Timer.
4. Press the appropriate digit to change the value. The default is 5 (60 seconds).
0 = Not Active
2 = 20 seconds
4 = 45 seconds
6 = 90 seconds
8 = 150 seconds
1 = 10 seconds
3 = 30 seconds
5 = 60 seconds
7 = 120 seconds
9 = 180 seconds
· Alternatively use the Next Data or Previous Data buttons to change the setting or press Remove to return
to the default setting.
· To exit phone based administration at any time, press the Release button. To select a different process use the
Next Procedure or Previous Procedure buttons or dial another feature code.
ETR 18D/ETR 34D Phone
1. At either or the first two extensions on the system, press Feature 0 0 followed by two presses of the first
intercom or call appearance button.
2. System Administration: is shown on the display.
3. Dial #127. The phone displays Hold Timer.
4. Press the appropriate digit to change the value. The default is 5 (60 seconds).
0 = Not Active
2 = 20 seconds
4 = 45 seconds
6 = 90 seconds
8 = 150 seconds
1 = 10 seconds
3 = 30 seconds
5 = 60 seconds
7 = 120 seconds
9 = 180 seconds
· Alternatively use the Next Data or Previous Data buttons to change the setting or press Remove to return
to the default setting.
· Exit programming by pressing Feature 00. You can also exit programming mode by lifting the handset, then
placing it back in the cradle.
10
114