Avaya IP Office Basic Edition - Clearing a Backup Alarm

Phone Based Administration Page 300
- Issue 6a (Thursday, February 22, 2018)IP Office Basic Edition
Comments on this document? infodev@avaya.com
17.3 Clearing a Backup Alarm
If an automatic backup fails, a backup failure alarm message appears instead of the system date and time on the first two
extensions in the system. After correcting the problem that caused the failure, you can clear the backup failure alarm.
1408/1416/9504/9508 Phone
1. At either of the first two extensions on the system, press Admin.
· To do the above during a call, you may need to press the PHONE button to display the Admin soft key
option. If you access phone administration during a call, only the SPEAKER, MUTE and HEADSET
buttons still affect the connected call.
2. Use the up or down arrow buttons to scroll the display to System Administration. When highlighted, press
Select.
3. Use the up or down arrow buttons to scroll the display to System Parameters. When highlighted, press
Select.
· Alternatively, dial # and the system administration code.
4. Use the up or down arrow buttons to scroll the display to Clear Backup Alarm. When highlighted, press
Select.
5. To clear the alarm press Proceed.
· Exit programming by pressing PHONE. Alternatively use the Back button to move to another menu.
M7324/M7324N/M7310/M7310N/T7316/T7316E Phone
1. At either of the first two extensions on the system, press Feature **config (ie. Feature **266344).
· If the system has a system password set, it is requested. Enter the password.
2. The phone displays System Admin.
3. Dial #123. The phone displays Clear Backup Alarm.
4. Press Enter to clear the backup alarm.
· To exit phone based administration at any time, press the Release button. To select a different process use the
Next Procedure or Previous Procedure buttons or dial another feature code.
ETR 18D/ETR 34D Phone
1. At either or the first two extensions on the system, press Feature 0 0 followed by two presses of the first
intercom or call appearance button.
2. System Administration: is shown on the display.
3. Dial #123. The phone displays Clear Backup Alarm.
4. Press Enter to clear the backup alarm.
· Exit programming by pressing Feature 00. You can also exit programming mode by lifting the handset, then
placing it back in the cradle.
10
114
22