Avaya IP Office Basic Edition - Page 158

Phone Based Administration Page 158
- Issue 6a (Thursday, February 22, 2018)IP Office Basic Edition
Comments on this document? infodev@avaya.com
M7324/M7324N/M7310/M7310N/T7316/T7316E Phone
1. At either of the first two extensions on the system, press Feature **config (ie. Feature **266344).
· If the system has a system password set, it is requested. Enter the password.
2. The phone displays System Admin.
3. Dial #603. The phone displays Internal Hotline Ext.
4. Enter the extension number for which you want to change the internal hotline settings;
5. At the Extension: prompt enter the alerting extension number.
6. Press the Next Item or Previous Item button for the next or previous extension respectively.
7. Press the Next Data or Previous Data button for the next or previous extension respectively.
· To exit phone based administration at any time, press the Release button. To select a different process use the
Next Procedure or Previous Procedure buttons or dial another feature code.
ETR 18D/ETR 34D Phone
1. At either or the first two extensions on the system, press Feature 0 0 followed by two presses of the first
intercom or call appearance button.
2. System Administration: is shown on the display.
3. Dial #603. The phone displays Internal Hotline Ext.
4. At the Extension: prompt enter the hotline extension number.
5. At the next Extension: prompt enter the alerting extension number.
6. Press the Next Item or Previous Item button for the next or previous extension respectively.
7. Press the Next Data or Previous Data button for the next or previous extension respectively.
· Exit programming by pressing Feature 00. You can also exit programming mode by lifting the handset, then
placing it back in the cradle.
114