Phone Based Administration Page 186
- Issue 6a (Thursday, February 22, 2018)IP Office Basic Edition
Comments on this document? infodev@avaya.com
ETR 18D/ETR 34D Phone
1. At either or the first two extensions on the system, press Feature 0 0 followed by two presses of the first
intercom or call appearance button.
2. System Administration: is shown on the display.
3. Dial #505. The phone displays Hunt Group.
4. At the Group: prompt, enter a group number.
5. At the Extension: prompt, enter the number of the extension to be programmed.
6. Enter 1 or 2. The default is 2 (Not Assigned), ie. the extension is not a member of the group.
·
Alternatively use the Next Data or Previous Data buttons to change the setting or press Remove to return
to the default setting.
7. Do one of the following:
·
To assign or unassign another extension, press Next Item or Prev Item until the extension number appears
on the display. Then repeat Step 6.
·
To program another group, press Next Procedure + Prev Procedure and enter a new group
number. Then repeat Steps 5 and 6.
·
Exit programming by pressing Feature 00. You can also exit programming mode by lifting the handset, then
placing it back in the cradle.
22 22
To Next Page
Loading...
