Avaya IP Office Basic Edition

To Next Page

To Previous Page

Phone Based Administration Page 212

- Issue 6a (Thursday, February 22, 2018)IP Office Basic Edition

Comments on this document? infodev@avaya.com

1408/1416/9504/9508 Phone

1. At either of the first two extensions on the system, press Admin.

To do the above during a call, you may need to press the PHONE button to display the Admin soft key

option. If you access phone administration during a call, only the SPEAKER, MUTE and HEADSET

buttons still affect the connected call.

2. Use the up or down arrow buttons to scroll the display to System Administration. When highlighted, press

Select.

3. Use the up or down arrow buttons to scroll the display to System Parameters. When highlighted, press

Select.

Alternatively, dial # and the system administration code.

4. Use the up or down arrow buttons to scroll the display to Transfer Return. When highlighted, press

Select.

5. The current setting is displayed.

6. Enter the number of rings 0 (off) to 9. Alternatively use the left or right arrow icons to toggle the settings or

Default to return to the default setting (4 Rings).

Exit programming by pressing PHONE. Alternatively use the Back button to move to another menu.

M7324/M7324N/M7310/M7310N/T7316/T7316E Phone

1. At either of the first two extensions on the system, press Feature **config (ie. Feature **266344).

If the system has a system password set, it is requested. Enter the password.

2. The phone displays System Admin.

3. Enter the number of rings 0 (off) to 9. The default is 4 rings.

Alternatively use the Next Data or Previous Data buttons to change the setting or press Remove to return

to the default setting.

To exit phone based administration at any time, press the Release button. To select a different process use the

Next Procedure or Previous Procedure buttons or dial another feature code.

ETR 18D/ETR 34D Phone

1. At either or the first two extensions on the system, press Feature 0 0 followed by two presses of the first

intercom or call appearance button.

2. System Administration: is shown on the display.

3. Dial #105. The phone displays Transfer Return.

4. Enter the number of rings 0 (off) to 9. The default is 4 rings.

Exit programming by pressing Feature 00. You can also exit programming mode by lifting the handset, then

placing it back in the cradle.

114

Avaya IP Office Basic Edition - Page 212