Phone Based Administration Page 235
- Issue 6a (Thursday, February 22, 2018)IP Office Basic Edition
Comments on this document? infodev@avaya.com
Button Programming: Auto Dial - Other
M7324/M7324N/M7310/M7310N/T7316/T7316E Phone
1. Do one of the following depending on whether you want to change the button programming of the extension you
are using or that of another extension.
To program the same extension
To program another extension
a. Press Feature and dial *1 or
*2 or *3.
·
If the system has a system
password set, it is requested.
Enter the password.
a. At either of the first two extensions on the system, press Feature
**user (ie. Feature **8737).
·
If the system has a system password set, it is requested. Enter the
password.
b. At the Extension: prompt enter the extension number of the extension you
want to program.
2. To select the button, press the corresponding button. For buttons up to 99, you can also dial the button number.
The current setting of the selected button is displayed.
3. Press the Intercom 2 button.
4. Enter the number for calls made using the button. The number can include * and # and the following special
characters:
Inserts a 1.5 second pause.
Send a hook-switch flash signal.
5. The button function is changed to AD-O.
·
To exit phone based administration at any time, press the Release button. To select a different process use the
Next Procedure or Previous Procedure buttons or dial another feature code.
ETR 18D/ETR 34D Phone
1. Do one of the following depending on whether you want to change the button programming of the extension you
are using or that of another extension.
To program the same extension
To program another extension
a. At the phone, press Feature 00.
b. Program Extension: is shown on the
display.
a. At either of the first two extensions on the system, press Feature
00 followed by two presses the first intercom or call appearance
button and one press of the second intercom or call appearance
button. Centralized Programming: is shown on the display.
b. At the Extension: prompt enter the number of the extension.
2. To select the button, press the corresponding button. For buttons up to 99, you can also dial the button number.
The current setting of that button is displayed.
3. Press Intercom 2.
4. Enter the number for calls made using the button. The number can include * and # and the following special
characters:
Inserts a 1.5 second pause.
Send a hook-switch flash signal.
·
On 9500 Series phones, these options are accessed by pressing More and select Pause, Stop or Recall as
required.
5. The button function is changed to AD-O followed by the stored number.
·
Exit programming by pressing Feature 00. You can also exit programming mode by lifting the handset, then
placing it back in the cradle.
114
To Next Page
Loading...
