Avaya IP Office Basic Edition - Page 251

Phone Based Administration Page 251
- Issue 6a (Thursday, February 22, 2018)IP Office Basic Edition
Comments on this document? infodev@avaya.com
Button Programming: Call Screening
· This function is only supported on a button that includes an LEDs/LCD. It will indicate when the function is on.
· If the user has this feature enabled, removing this button will turn the feature off.
· Any call currently being screened will continue being screened but further calls will not receive screening.
· Direct Line Pickup can be used to answer a call that is being screened.
1408/1416/9504/9508 Phone
1. At either of the first two extensions on the system, press Admin.
2. Use the up or down arrow buttons to scroll the display to Centralized Programming. When highlighted,
press Select.
3. At the Extension: prompt enter the extension that you want to configure.
4. Press the button to edit. Alternatively using the up or down arrows, scroll to Button Programming and
press Select. Enter from 03 to 99 or press the corresponding button.
5. Press Program and either dial #25 or use the up or down arrow buttons to scroll the display to Call
Screening and press Select.
6. The button function is changed to Call Screening.
· Exit programming by pressing PHONE. Alternatively use the Back button to move to another menu.
M7324/M7324N/M7310/M7310N/T7316/T7316E Phone
1. At either of the first two extensions on the system, press Feature **user (ie. Feature **8737).
2. If the system has a system password set, it is requested. Enter the password.
3. At the Extension: prompt enter the extension number of the extension you want to program.
4. To select the button, press the corresponding button. For buttons up to 99, you can also dial the button number.
The current setting of the selected button is displayed.
5. Dial Feature 939.
6. The button function is changed to Call Screening.
· To exit phone based administration at any time, press the Release button. To select a different process use the
Next Procedure or Previous Procedure buttons or dial another feature code.
ETR 18D/ETR 34D Phone
1. At either of the first two extensions on the system, press Feature 00 followed by two presses the first intercom
or call appearance button and one press of the second intercom or call appearance button. Centralized
Programming: is shown on the display.
2. At the Extension: prompt enter the number of the extension.
3. To select the button, press the corresponding button. For buttons up to 99, you can also dial the button number.
The current setting of that button is displayed.
4. Dial FEATURE 25. The button function is changed to Call Screening.
· Exit programming by pressing Feature 00. You can also exit programming mode by lifting the handset, then
placing it back in the cradle.
114