Phone Based Administration Page 274
- Issue 6a (Thursday, February 22, 2018)IP Office Basic Edition
Comments on this document? infodev@avaya.com
M7324/M7324N/M7310/M7310N/T7316/T7316E Phone
1. At either of the first two extensions on the system, press Feature **config (ie. Feature **266344).
·
If the system has a system password set, it is requested. Enter the password.
2. The phone displays System Admin.
3. Dial #503. The phone displays Night Service Button. The current setting is displayed. If night service is
already assigned to a button, that button is lit.
4. Enter 1 or 2. The default is 2 (Not Assigned).
·
Alternatively use the left or right arrow icons to toggle through the settings or Default to return to the
default setting.
5. If active, press 3 to select the button to which night service is assigned. At the Button: prompt, press the button
to which you want night service assigned or enter the button number.
·
If you do not select a button, it will be automatically assigned. For DS and ETR phones, it is assigned the first
button after any line appearances. For BST phones, is it assigned to the first button after any intercom buttons
that is not a line appearance.
·
To exit phone based administration at any time, press the Release button. To select a different process use the
Next Procedure or Previous Procedure buttons or dial another feature code.
ETR 18D/ETR 34D Phone
1. At either or the first two extensions on the system, press Feature 0 0 followed by two presses of the first
intercom or call appearance button.
2. System Administration: is shown on the display.
3. Dial #503. The phone displays Night Service Button. The current setting is displayed. If night service is
already assigned to a button, that button is lit.
4. Enter 1 or 2. The default is 2 (Not Assigned).
·
Alternatively use the left or right arrow icons to toggle through the settings or Default to return to the
default setting.
5. If active, press 3 to select the button to which night service is assigned. At the Button: prompt, press the button
to which you want night service assigned or enter the button number.
·
If you do not select a button, it will be automatically assigned. For DS and ETR phones, it is assigned the first
button after any line appearances. For BST phones, is it assigned to the first button after any intercom buttons
that is not a line appearance.
·
Exit programming by pressing Feature 00. You can also exit programming mode by lifting the handset, then
placing it back in the cradle.
114
To Next Page
Loading...
