Phone Based Administration Page 83
- Issue 6a (Thursday, February 22, 2018)IP Office Basic Edition
Comments on this document? infodev@avaya.com
Line Settings: Group Call Distribution
M7324/M7324N/M7310/M7310N/T7316/T7316E Phone
1. At either of the first two extensions on the system, press Feature **config (ie. Feature **266344).
·
If the system has a system password set, it is requested. Enter the password.
2. The phone displays System Admin.
3. Dial #206. The phone displays Group Call Distrib.
4. At the Group: prompt, enter a group number 1 to 6.
5. At the Line: prompt, enter the desired line number 01 to 64.
6. Enter 1 (assigned) or 2 (not assigned). The default is 2 (not assigned).
·
Alternatively use the Next Data or Previous Data buttons to change the setting or press Remove to return
to the default setting.
·
To exit phone based administration at any time, press the Release button. To select a different process use the
Next Procedure or Previous Procedure buttons or dial another feature code.
ETR 18D/ETR 34D Phone
1. At either or the first two extensions on the system, press Feature 0 0 followed by two presses of the first
intercom or call appearance button.
2. System Administration: is shown on the display.
3. Dial #206. The phone displays Group Call Distrib.
4. At the Group: prompt, enter a group number 1 to 6.
5. At the Line: prompt, enter the desired line number 01 to 64.
6. Enter 1 (assigned) or 2 (not assigned). The default is 2 (not assigned).
·
Exit programming by pressing Feature 00. You can also exit programming mode by lifting the handset, then
placing it back in the cradle.
114
To Next Page
Loading...
