Avaya JEM24 Installing

System parameter
name
TLV name Impact
A check is made as to whether a reset is necessary to obtain a
new IP address due to a change in the values of the
parameters L2Q or L2QVLAN.
This TLV is ignored if:
• The value of USE_DHCP is 0 and the value of IPADD is not
0.0.0.0.
• The Application Type is not 1 (Voice) or 2 (Voice Signaling).
• The Unknown Policy Flag (U) is set to 1.
SIP_CONTROLL
ER_LIST
Proprietary Call
Server TLV
SIP_CONTROLLER_LIST will be set to the IP addresses in
this TLV value.
Note:
This parameter cannot be used in an environment where
both SIP phones and H.323 phones exist.
TLSSRVR and
HTTPSRVR
Proprietary File
Server TLV
L2Q Proprietary 802.1 Q
Framing
If the value of TLV = 1, L2Q is set to 1 (On).
If the value of TLV = 2, L2Q is set to 2 (Off).
If the value of TLV = 3, L2Q is set to 0 (Auto).
A check is made as to whether a reset is necessary to obtain a
new IP address due to a change in the values of the
parameters L2Q or L2QVLAN.
This TLV is ignored if:
• The value of USE_DHCP is 0 and the value of IPADD is not
0.0.0.0.
• The current L2QVLAN value was set by an IEEE 802.1
VLAN name.
• The current L2QVLAN value was set by a TIA LLDP MED
Network Policy (Voice) TLV.
Configuration through DHCP
The obtain network and configuration information using DHCP protocol. You can configure the
DHCP server to provide the following information to the device:
• Avaya Aura
®
Session Manager address.
• IP address
• Subnet mask
Configuring servers and VLAN
December 2018 Installing and Administering Avaya J100 Series IP Phones 108
Comments on this document? infodev@avaya.com

Avaya JEM24 Specifications

General

Brand	Avaya
Model	JEM24
Category	IP Phone
Language	English